Siemens Sinumerik 840D sl Programming Manual page 179

42520
SD Number
Default setting: 0
Change valid IMMEDIATELY
Data type: DOUBLE
Meaning:
42522
SD Number
Default setting: 0
Change valid IMMEDIATELY
Data type: DOUBLE
Meaning:
42524
SD Number
Default setting: 0
Change valid IMMEDIATELY
Data type: DOUBLE
Meaning:
42526
SD Number
Default setting: 0
Change valid IMMEDIATELY
Data type: DOUBLE
Meaning:
43340
MD number
Default setting:
Change valid IMMEDIATELY
Data type: DOUBLE
Meaning:
ISO Milling
Programming Manual, 06/09, 6FC5398-7BP10-1BA0
CORNER_SLOWDOWWN_START
Start of feedrate reduction in G62
min. input limit: 0
Path length from which the feedrate is reduced before the corner in G62
CORNER_SLOWDOWN_END
End of feedrate reduction in G62
min. input limit: 0
Path length up to which the feedrate remains reduced after a corner in G62.
CORNER_SLOWDOWN_OVR
Override for feedrate reduction in G62
min. input limit: 0
Override with which the feedrate is multiplied at the corner in G62.
CORNER_SLOWDOWN_CRIT
Corner detection in G62, G21
min. input limit: 0
Angle from which a corner is considered for the feedrate reduction with G62, G21.
EXTERN_REF_POSITION_G30_1
Reference point position for G30.1
min. input limit:
Setting data
Reference point position for G30.1.
This setting data is evaluated in CYCLE328.
Protection level: 7/7
Valid as of software version: 6
Protection level: 7/7
Valid as of software version: 6
Protection level: 7/7
Valid as of software version: 6
Protection level: 7/7
Valid as of software version: 6
Protection level:
Valid as of software version:
Data Description
C.4 Channel-specific setting data
max. input limit: Any
Unit: mm
max. input limit: Any
Unit: mm
max. input limit: Any
Unit: PERCENT
max. input limit: Any
Unit: Degree
max. input limit:
Unit:
179