Siemens Sinumerik 840D sl Programming Manual page 153

10656
MD number
Default setting: "CHR"
Changes effective after POWER ON
Data type: STRING
Meaning:
MD cannot be changed for SINUMERIK 802D sl.
10704
MD number
Default setting:
Change becomes effective after
Data type: BYTE
Meaning:
MD cannot be changed for SINUMERIK 802D sl.
ISO Milling
Programming Manual, 06/09, 6FC5398-7BP10-1BA0
CHAMFER_NAME
Adjustable name for chamfer in the contour short description
min. input limit: -
The name under which the chamfer is programmed in the contour short description can be
adjusted. Hence, for instance, identical programming in different language modes can be
implemented:
If "C" is specified as name, then the radius is specified the same way in Siemens
programming as in ISO dialect.
The identifier must be unique, i.e. there should be axes, variables, macros etc. having the
same name.
The setting is effective for Siemens G code programming, i.e. G290.
The chamfer is effective in the original direction of movement. Alternatively, the chamfer
length can be programmed under the CHF identifier.
DRYRUN_MASK
Activation of dry run feedrate
min. input limit: -
DRYRUN_MASK == 0
Dryrun should be switched on and off only at end of block.
DRYRUN_MASK == 1
the deactivation/activation of the dry run feedrate is also possible during program processing
Notice: The axes are stopped for the duration of the reorganization operation after the dry
run feedrate is activated.
DRYRUN_MASK == 2
Dry run can be switched on and off in each phase, and the axes are not stopped.
Notice: The function only becomes effective with a block which comes "later" in the program
run! The function is effective from the next (implicit) stop reset block.
Protection level: 2/7
Valid as of software version: 5
Protection level:
Valid as of software version:
Data Description
C.1 General machine data
max. input limit: -
Unit: -
max. input limit: -
Unit: -
153