Principles of programming
1.2 Preconditions for the feed
i.e., the programmed path is traversed within half a minute.
Note
The time inverse feed 1/min G93 is not implemented for SINUMERIK 802D.
1.2.6
Revolutional feedrate (G95)
On entering G95, the feed is executed in the mm/revolution unit or inch/revolution related to
the master spindle.
Note
All of the commands are modal. If the G feed command is switched among G93, G94 or
G95, the path feed must be reprogrammed. The feed can also be specified in
degree/revolution for the machining with rotary axes.
16
Programming Manual, 06/09, 6FC5398-7BP10-1BA0
ISO Milling