WAGO-I/O-SYSTEM 750
750-495 3-Phase Power Measurement Module
8.1.6
"Factory Settings" Tab
After entering a password (see "Energy" tab above), you can reset all parameters
of the I/O module to their factory settings on the "Factory Settings" tab.
List of factory settings
A list of factory settings may be found in section "Appendix".
Use I/O Module Settings [Restore] to reset the I/O module settings only.
Calibration data remains unchanged.
Use Calibration Data [Restore] to reset the calibration data only. The I/O module
settings remain unchanged.
Use Total [Restore] to reset all I/O module settings and calibration data.
These actions are carried out immediately and cannot be undone. Therefore, the
[Save] button is disabled at the bottom of the window.
Manual
Version 1.0.0
Commissioning
87