Inserting And Removing Devices; Inserting I/O Module; Figure 12: Insert I/O Module (Sample); Figure 13: Snap The I/O Module Into Place (Sample) - WAGO -I/O-SYSTEM 750 Series Manual

64 Mounting
Pos : 67.6 /Serie 750 (WAGO-I/O-SYST EM)/M ontieren/D emontieren/Geräte einfüg en und entfer nen - Ü berschrift 2 @ 3\mod_1231768483250_21.doc x @ 25950 @ 2 @ 1
6.2

Inserting and Removing Devices

Pos : 67.7 /All e Seri en ( Allgemei ne Module)/Wic htige Erläuterungen/Sicherheits- und sons tige Hi nweis e/Ac htung/Achtung: Arbeiten an Ger äten nur s pannungsfr ei durc hführ en! @ 6\mod_1256193963573_21.doc x @ 43426 @ @ 1
Perform work on devices only if the system is de-energized!
Working on devices when the system is energized can damage the devices.
Therefore, turn off the power supply before working on the devices.
Pos : 67.8 /Serie 750 (WAGO-I/O-SYST EM)/M ontieren/D emontieren/Bus klemme einfüg en @ 3\mod_1231769726703_21.doc x @ 25989 @ 3 @ 1
6.2.1

Inserting I/O Module

1. Position the I/O module so that the tongue and groove joints to the fieldbus
coupler/controller or to the previous or possibly subsequent I/O module are
engaged.

Figure 12: Insert I/O module (sample)

2. Press the I/O module into the assembly until the I/O module snaps into the
carrier rail.

Figure 13: Snap the I/O module into place (sample)

With the I/O module snapped in place, the electrical connections for the data
contacts and power contacts (if any) to the fieldbus coupler/controller or to the
previous or possibly subsequent I/O module are established.
Pos : 67.9 /Dokumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
WAGO-I/O-SYSTEM 750
750-495 3-Phase Power Measurement Module
Manual
Version 1.0.0