Remote Evac-Nl And Evac-Nl Mimic Display Driver; Remote 20-Zone Evac-Nl Indicator - Siemens FS720 Mounting & Installation

6.32 Remote EVAC-NL and EVAC-NL mimic display

6.32.1 Remote 20-zone EVAC-NL indicator

Building Technologies
Fire Safety
driver
X1
3
X2
2
Figure 114: Example of remote mounting of the 20-zone EVAC-NL indicator in an Eco housing
1 EVAC-NL connector board FTI2002-N1
2 Eco housing (example)
3 Power supply (70 W) (example)
4 EVAC-NL connector board FTI2002-N1
5 Operating add-on FCM7221-H3
6 EVAC-NL operating unit FTO2007-N1
7 EVAC-NL operating unit FTO2007-N1
Preparation
The 20-zone EVAC-NL indicator is available as a component in the operating add-
on FCM7221-H3. It can be installed in a station as an operating add-on or remotely
operated in any housing. In this instance it is also supplied using any separate
power supply, which can be installed in the housing, or via an external power
supply.
The following components are also needed to operate the remote operating add-on
FCM7221-H3:
● Any housing or Eco housing FH7201-Z3
● Any DC 24 V power supply or power supply (70 W) FP2015-A1
● 1 or 2 EVAC-NL connector boards FTI2002-N1 (1 each per 10 zones)
● 34 pin x 1 mm ribbon cable for connecting to the EVAC-NL connector board
FTI2002-N1
● RS485 module FCA2001-A1 for installation in the associated control panel
Installing, exchanging and connecting modules

Remote EVAC-NL and EVAC-NL mimic display driver

4
1 2 1 2
X2 X4
33 34 33 34
1 2 1 2
X3 X5
33 34 33 34
1
X1
1 2 1 2
X2 X4
33 34 33 34
1 2 1 2
X3 X5
33 34 33 34
1
X1
1
6
5
6 7
X402 X400 X402 X400
X1
S20 X1 S20
193 | 222
A6V10210390_j_en_--
2015-12-15