Din Rail Clip Mounting - Siemens FS720 Mounting & Installation

6.15.2 DIN rail clip mounting

Building Technologies
Fire Safety
1. Position the Ethernet module (4) as shown.
2. Push the Ethernet module (4) into the slot opening so the plug-in contacts (5)
slide into the connector on the Ethernet switch.
3. Ensure that the Ethernet module (4) slides into the positioning aids (7).
4. Use the fixing screw (3) to fix the Ethernet module in the threaded hole (6).
5. Wire up the Ethernet module according to chapter 'Wiring'.
The diagram below shows how to mount the DIN rail clip on the FN2012.
2
5
1
1 2x countersunk screws
2 DIN rail clip in mounting position
3 4x spacers with thread for fixing the DIN rail clip
4 Ethernet switch (modular) FN2012
5 Flange with retaining clamp
1. Place the DIN rail clip (2) in the required mounting position relative to the
FN2012 (4) so that the flange with the retaining clamp (5) is at the bottom.
2. Fasten the DIN rail clip (2) using both countersunk screws (1) at the
spacers (3) located one above the other.
Installing, exchanging and connecting modules
Installing an Ethernet switch (modular) FN2012
4
3
6
125 | 222
A6V10210390_j_en_--
2015-12-15