6.14.2 Installing the modules
Building Technologies
Fire Safety
The process of installation using the mounting kit is identical for all housing
variants and applies to the following modules:
●
Ethernet switch (MM) FN2008-A1
●
Security module (firewall) FN2009-A1
3
2
1
Figure 58: Example: Installation in the Standard empty housing
1
Bottom DIN rail (for optional second module)
2
Angle plate
3
Top DIN rail with retaining bracket for FN2008-A1 or FN2009-A1
4
FN2008-A1 or FN2009-A1
1. Attach the module's top snap-in guide (4) onto the top DIN rail (3) at an angle
from above and gently press down until it snaps into place.
2. If necessary, install a second module on the lower DIN rail (1).
–
Install a retaining bracket for a second module.
3. Wire the module as described below.
Installing, exchanging and connecting modules
Ethernet switch FN2008 and safety module FN2009
4
6
115 | 222
A6V10210390_j_en_--
2015-12-15