Siemens FS720 Mounting & Installation page 36

Mounting procedure
4
36 | 222
Building Technologies
Fire Safety
1. Mount the rear panel.
2. Install the options in the rear panel.
3. Mount options on the operating unit.
4. Secure the operating unit and the operating add-on (if available) on the hinge
of the rear panel and wire this up.
5. Fit the batteries (do not connect).
6. Insert the inscription strips into the operating unit or the operating add-on.
7. Screw the operating unit or the operating add-on to the wall.
8. Fit the cover(s) and screw into place.
9. Finally the type plate must be mounted on the outside of the control panel
housing so that it is clearly visible (provision EN 54-2). The installation number
(No.:) and the date of commissioning (Date:) must be completed upon
commissioning.
 The station is then ready for commissioning.
Siemens Switzerland Ltd
Fire Safety & Security Products
CH-6301 Zug
FC722
85...265VAC
EN54-2 / (PSU:EN54-4)
Prod. Date:
Figure 15: Example of a type plate
90VAC
G209076
A6V10210390_j_en_--
2015-12-15