Lowering In The Safety Locks; Setting The Columns; Control System - stertil-KONI ST 1082-FS Installation, Operation And Maintanance Instructions

5

5.2.6 Lowering in the safety locks

For lowering on the safety locks, simply press the DOWN button (4).
The column lifts will then lower no more than 1 3/8", before the safety pawls engage
the teeth in the safety lock profile. The drop-safeguard pawls can then no longer be
released. If the UNLOCK button (6) is now pressed, there will be no sound of the
pawls being released. Raise the column lifts again (to relieve the safety lock) so that
the column lifts can resume lowering.
Warning
w
Always lower the column lifts in the safety locks before carrying out any work on the
vehicle.
The buttons for raising, normal lowering and lowering in the safety locks are of the
"dead man" type (hold to run). Operation continues as long as the button remains
pressed, and stops immediately once the button is released.
Note
n
In the event of malfunction, consult the troubleshooting section (see section
"Troubleshooting" on page
5.3

Setting the columns

5.3.1 Control system

Set the control system of the mobile column lift as follows:
1. Configure the column lifts in a full circuit as specified in
on page
- The column sequence in this circuit is random; master columns or slave
columns can be set up at all positions; see
page
- Configure at least one column as the master column in a system.
Note
n
The maximum number of column lifts in a system is 28.
2. On the master columns:
- Ensure that the mains switch is set to 0 (OFF), then connect the mains power
cable to the correct mains power outlet.
- Set the mains switch to 1 (ON).
If the circuit has more than one master column, ensure that all other main
switches are set to 1 (ON).
- Ensure that all master columns are connected to the mains.
3. Ensure that the emergency shut-down button of all master columns has been
released.
Operating instructions (Version F)
Operation
53).
28.
28.
Figure 4.2 "Linking columns"
Figure 4.2 "Linking columns" on
37
7.5
ST 1082 & ST 1100