Adjustment Of The Pallet Lifting Mechanism - stertil-KONI ST 1082-FS Installation, Operation And Maintanance Instructions

7

7.6.2 Adjustment of the pallet lifting mechanism

1. With the lever in position 3 (see
adjustment is correct, the cylinder should now give about 8mm lift per stroke.
Chain
Figure 7.2 Pallet lifting mechanism
2. Set the lever to position 2 and move the drawbar up and down; the cylinder will now
not lift if the setting is correct.
3. If the cylinder lifts, loosen nut 1 and turn the adjusting screw clockwise.
4. If the cylinder sinks down, turn the adjusting screw anti-clockwise until the cylinder
no longer sinks. Raise the cylinder to the top position and set the lever to position 1;
the cylinder should now be lowered.
5. If it does not lower, or only does so slowly, tighten the adjusting screw a little.
6. Repeat these steps until the movements at each lever position are correct.
7. Once the adjustments are correct, re-tighten nut 1.
Operating instructions (Version F)
Service and troubleshooting
Figure 7.2 ), move the drawbar up and down. If the
Lever plate (C)
Nut 1
Adjusting screw
61
1
2
3
Lever
Drawbar
ST 1082 & ST 1100