Manufacturers Instructions To The Lift Owner/Employer - stertil-KONI ST 1082-FS Installation, Operation And Maintanance Instructions

2
• Use the lifting columns only on a hard and level
floor with sufficient bearing capacity, see the
specifications for floor pressure and floor load in
Table 3.1 "Specifications" on page
• Whenever a vehicle is raised on the lift, always
raise the mobile column lifts to at least above the
first safety lock.
• Always lower the mobile column lifts into the
safety lock before starting any work on the vehicle
or leaving the vehicle unattended.
FOR YOUR AND OTHER PEOPLES SAFETY: SAVE
THESE INSTRUCTIONS.
Warning
w
All accessories supplied with this lift are to be used on this lift only.
Accessories from other lifts are not acceptable and could result in injury to the
user.
2.4 Manufacturers instructions to the lift
owner/employer
The owner/employer shall:
• Ensure that lift operators are qualified and that they are trained in the safe
use and operation of the lift using the manufacturers operating
instructions; ALI/SM 01-1, ALI Lifting it Right safety manual; ALI/ST-90, ALI
Safety Tips card; ANSI/ALI ALOIM-2008, American National Standard for
Automotive Lifts-Safety Requirements for Operation Inspection and
Maintenance; ALI/WL Series, ALI Uniform Warning Label Decals/Placards;
SAE J2184, Vehicle Lift Points for Service Garage Lifting.
• Establish procedures to periodically inspect the lift in accordance with the
lift manufacturers instructions; ANSI/ALI ALOIM-2008, American National
Standard for Automotive Lifts-Safety Requirements for Inspection and
Maintenance; and the employer shall ensure that lift inspectors are
qualified and that they are adequately trained in the inspection of the lift.
Operating instructions (Version F)
Safety
17
21.
ST 1082 & ST 1100