Omron Sysmac FH Series Hardware Setup Manual page 71

Connector name
(H) EtherCAT commu-
nication connector
(IN)
(I) EtherCAT commu-
nication connector
(OUT)
(J) Encoder connec-
tor
(K) Camera connec-
tor
(L) Power supply ter-
minal connector
(A)
(B)
(C)
(D)
(E)
(F)
(K)
(L)
(M)
(N)
LED name
(A) POWER LED
(B) ERROR LED
(C) RUN LED
(D) ACCESS LED
(E) SD POWER LED
(F) SD BUSY LED
(G) EtherCAT RUN
LED
(H) EtherCAT
LINK/ACT IN LED
(I) EtherCAT
LINK/ACT OUT
LED
(J) EtherCAT ERR
LED
FH Series Vision System Hardware Setup Manual (Z366-E1)
Connect the opposed EtherCAT device.
Connect the opposed EtherCAT device.
Connect an encoder.
Connect cameras.
Connect a DC power supply. Wire the FH Sensor Controller independently on
other devices.
Wire the ground line. Be sure to ground the FH Sensor Controller alone.
Use an attachment power terminal (male) for installation. For details, refer to
5-3 Sensor Controller Installation on page 5 - 5.
(G)
(H)
(I)
(J)
Lit while power is ON.
Lit when an error has occurred.
Lit while the layout turned on output setting is displayed.
Blinks while the internal nonvolatile memory is accessed.
Lit while power is supplied to the SD memory card and the card is usable.
Blinks while the SD memory card is accessed.
Lit while EtherCAT communications are usable.
Lit when connected with an EtherCAT device, and blinks while performing com-
munications.
Lit when connected with an EtherCAT device, and blinks while performing com-
munications.
Lit when EtherCAT communications have become abnormal.
3 Configuration
Description
Description
3
3 - 11