Omron Sysmac FH Series Hardware Setup Manual page 68

3 Configuration
Indicator
Lamps
Supply Voltage
Current
consump-
tion
Built-in FAN
Usage
Environ-
ment
3 - 8
Series
Type Standard Controller(4 cores)
Model FH-3050
Encoder Interface Input voltage: 5 V ± 5%
Signal: RS-422A Line Driver Level
Phase A/B/Z: 1 MHz
Monitor Interface DVI-I output (Analog RGB & DVI-D single link) x 1
USB I/F USB2.0 host x 4(BUS Power: 5 V/0.5 A per port)
SD Card I/F SDHC x 1
Main POWER: Green
ERROR: Red
RUN: Green
ACCESS: Yellow
Ethernet NET
RUN:
Green
LINK/
ACT: Yel-
low
SD Card SD POWER: Green
SD BUSY: Yellow
EtherCAT ECAT RUN: Green
LINK/ACT IN: Green
LINK/ACT OUT: Green
ECAT ERR: Red
20.4 VDC to 26.4 VDC
•
When connecting 5.0A
an intelligent com- max.
pact digital camera
•
When connecting
the following light-
ing or lighting con-
trollers without an
external power sup-
ply
- FLV-TCC1
- FLV-TCC4
- FLV-TCC3HB
- FLV-TCC1EP
- FL-TCC1
•
When connecting
the following light-
ing or lighting con-
trollers
- FL-TCC1PS
- FL-MD£MC
Other than above 4.1A
max.
Yes
Ambient temperature Operating: 0°C to +50°C
range Storage: -20 to +65°C (with no icing or condensation)
FH-3000 Series
FH-3050- FH-3050-
10 20
NET RUN1: Green NET
LINK/ACT1: Yellow RUN:
NET RUN2: Green Green
LINK/ACT2: Yellow LINK/
ACT: Yel-
low
7.0A 11.5A 4.7A
max. max. max.
4.8A 6.8A 3.6A
max. max. max.
FH Series Vision System Hardware Setup Manual (Z366-E1)
FH-1000 Series
Standard Controller(2 cores)
FH-1050- FH-1050-
FH-1050
10 20
NET RUN1: Green
LINK/ACT1: Yellow
NET RUN2: Green
LINK/ACT2: Yellow
6.5A 10.9A
max. max.
4.3A 6.2A max.
max.