Omron Sysmac FH Series Hardware Setup Manual page 201

CN1: Left-side connector (No. 1 to 34)
CN2: Right-side connector (No. 35 to 68)
Cable, I/O connector and Terminal Block
Use the following parallel I/O cable.
Name
Parallel I/O XW2Z-
cable S013-£
Parallel I/O XW2Z-££
cable for
£EE
Connector-
Terminal
Conversion
Unit
Connector- XW2R-
Terminal
£34GD-T
Conversion
Unit for
general-
purpose
l XW2Z-S013-£
FH Series Vision System Hardware Setup Manual (Z366-E1)
Model Description
Specialized for FH series
Cable length: 2 m, 5 m
Min. bending radius: 10
mm
Specialized for FH series
Cable length: 0.5 m, 1 m,
1.5 m, 2 m, 3 m, 5 m
Min. bending radius: 83.2
mm
-
Remark
•
Two these cables are needed to use all I/O signals.
•
One side of this cable is flat cable and another side
of it is a connector.
•
Connect the parallel I/O cable with securing the
minimum bending radius and more.
•
Cable length is set to £ in the model number. (2 = 2
m, 5 = 5 m)
•
Two these cables are needed to use all I/O signals.
•
One side of this cable is flat cable and another side
of it is a connector.
•
Connect the parallel I/O cable with securing the
minimum bending radius and more.
•
Cable length is set to £ in the model number. (050
= 0.5 m, 100 = 1 m, 150 = 1.5 m, 2 = 2 m, 300 = 3
m, 500 = 5 m)
•
Connectable Connector-Terminal Block Conversion
Unit: : XW2R-£34GD-T
The following is set to £ in the model number.
For details, refer to the XW2R Series catalog (Cat. No.
G077).
6 I/O Interface
6
6 - 5