EMS AIRFLOW Prophylaxis Master Instructions For Use Manual page 12

Power your device
You can now connect the power cord to the mains grid.
Protective earth is required!
Be sure your power grid has an efficient protective earth.
Installation of the wireless pedal
The optional wireless pedal supplied with your device is already paired and ready to use (Note: A
pedal can only command one single device at a time. Pairing is maintained even if the batteries are
removed).
When you receive your new machine, all you need to do is insert the two (2) AA lithium batteries
into the wireless pedal and your device is ready to work.
In case you replace your pedal, you will need to pair it with your device. For instructions, please
read the specific Maintenance & Troubleshooting chapter.
The Bluetooth radio is automatically disabled (powered off) when a wired pedal connected.
®
The wireless pedal uses a low power, 8 dBm EIRP max, Bluetooth
communicate with the control unit. Interference may occur in the vicinity of this equipment.
Portable RF communications equipment (including peripherals such as antenna cables and external
antennas) should be used no closer than 30 cm (12 inches) to any part of the device, including
cables. Otherwise, degradation of the performance of this equipment could result.
ENGLISH
Insert two (2) AA 1.5V lithium batteries into the wireless pedal. Close
the cover and operate your device.
Risk of fire: use only batteries that have current limiter/short-circuit
and over-temperature protection (compliant to IEC 60086-4:2014
Safety of lithium batteries).
FB-618/AU – rev.E – ed.2019/08
Voltage: 100-240 Vac
Frequency: 50 to 60 Hz.
Operating current: 4 A max.
2.4 GHz radio, to
®
12/48