Danfoss VLT AutomationDrive FC 300 Operating Instructions Manual page 30

3. How to Install
3.3.5. Access to Control Terminals
All terminals to the control cables are located underneath the terminal
cover on the front of the frequency converter. Remove the terminal cover
with a screwdriver.
3
Remove front-cover to access control terminals. When replacing the
front-cover, please ensure proper fastening by applying a torque of 2 Nm.
30
Illustration 3.20: Access to control terminals for A2, A3, B3, B4, C3 and
C4 enclosures
Illustration 3.21: Access to control terminals for A5, B1,B2, C1 and C2
enclosures
MG.33.AB.02 - VLT is a registered Danfoss trademark
®
VLT AutomationDrive FC 300 Operating
130BT248
Instructions