How To Read These Operating Instructions - Danfoss VLT AutomationDrive FC 300 Operating Instructions Manual

®
VLT AutomationDrive FC 300 Operating
Instructions

1. How to Read these Operating Instructions

1.1.1. How to Read these Operating Instructions
®
VLT AutomationDrive FC 300 is designed to provide high shaft performance on electrical motors. Please read this manual carefully for proper use.
Incorrect handling of the frequency converter may cause improper operation of the frequency converter or related equipment, shorten lifetime or cause
other troubles.
These Operating Instructions will help you get started, install, program, and troubleshoot your VLT
The VLT ® AutomationDrive FC 300 comes in twoshaft performance levels. The VLT
301 ranges from scalar (U/f) to VVC+ and handles asynchronous motors only. FC 302 is a high performance frequency converter for asynchronous as
well as permanent motors and handles various kinds of motor control principles such as scalar (U/f), VVC+ and Flux vector motor control.
These Operating Instructions cover both FC 301 and FC 302. Where information covers both series, we refer to FC 300. Otherwise, we refer specifically
to either FC 301 or FC 302.
Chapter 1, How to Read these Operating Instructions, introduces the manual and informs you about the approvals, symbols, and abbreviations
used in this literature.
Chapter 2, Safety Instructions and General Warnings, entails instructions on how to handle the FC 300 correctly.
Chapter 3, How to Install, guides you through mechanical and technical installation.
Chapter 4, How to Programme, shows you how to operate and programme the FC 300 via the Local Control Panel.
Chapter 5, General Specifications, contains technical data about FC 300.
Chapter 6, Troubleshooting, assists you in solving problems that may occur when using FC 300.
®
MG.33.AB.02 - VLT is a registered Danfoss trademark
1. How to Read these Operating Instructions
®
AutomationDrive FC 300.
AutomationDrive FC 300 comes in two shaft performance levels. FC
1
3