Danfoss VLT AutomationDrive FC 300 Operating Instructions Manual page 19

®
VLT AutomationDrive FC 300 Operating
Instructions
Illustration 3.2: With heavier drives, use a lift. First wall-mount the 2 lower bolts - then lift the drive onto the lower bolts - finally fasten the drive against
the wall with the 2 top bolts.
3.2.2. Panel Through Mounting
A Panel Through Mount Kit is available for frequency converter series VLT
In order to increase heatsink cooling and reduce panel depth, the frequency converter may be mounted in a through panel. Furthermore the in-built fan
can then be removed.
The kit is available for enclosures A5 through C2.
NB!
This kit cannot be used with cast front covers. No cover or imminent plastic cover must be used instead.
Information on ordering numbers is found in the
More detailed information is available in the
HVAC Drive, VLT
®
Design Guide Ordering Numbers.
, section
Panel Through Mount Kit instruction, MI.33.H1.yy,
MG.33.AB.02 - VLT is a registered Danfoss trademark
Aqua Drive and VLT Automation Drive.
® ®
where yy=language code.
3. How to Install
3
19