Table of Contents
Advertisement
Pic. 101
Service parameters, page 8
Primary-Airflap Autom. Ignition – can only be set by the manufacturer or service organization,
the primary flap position that will be set during automatic wood ignition with pellets
Secondary-Airflap Autom. Ignition – can only be set by the manufacturer or service organiza-
tion, the secondary flap position that will be set during automatic wood ignition with pellets
Oxygen setpoint max. power - the oxygen value by which the boiler will control the combus-
tion process at maximum power
Oxygen setpoint min. power - the oxygen value by which the boiler will control the combus-
tion process at minimum power
Difference boiler temperature Start - after the boiler temperature drops below this set value,
the boiler is switched on
Difference boiler temperature Stop - after exceeding the set boiler temperature by this set
value, the boiler is switched off
Set night from (hour) - if the heating circuit is connected we determine the hour of night start
when the heating circuit can reduce the temperature
Set night to (hour) - if the heating circuit control is connected we determine the hour of night
termination
92
Advertisement
Table of Contents
