Dx80 Gatewaypro; Dx83 Ethernet Bridge - Banner Sure Cross DX80 Series Instruction Manual

®
Sure Cross Performance DX80 Wireless I/O Networks
The GatewayPro has no serviceable parts inside the housing and no wiring chamber. During setup or standard operation,
there should not be a need to open the GatewayPro.

2.3 DX80 GatewayPro

The GatewayPro has many of the same features as the Gateway and Node, including the LEDs, the buttons, LCD, and
Euro-style connector.

2.4 DX83 Ethernet Bridge

The DX83 Ethernet Bridge uses the same housing and same mounting holes as the Gateway and Node.
8
1. Industrial ethernet port, female.
1
2. Rotary switch 1 (left). Sets the Network ID (NID) to a hexidecimal value
from 0 to F, for a total of 16 Network IDs. A Gateway and its
2
corresponding Nodes must be assigned the same Network ID.
3. Rotary switch 2 (right). On the Gateway, sets the Gateway's LCD
viewing device address. The Gateway is predefined as Device Address 0.
On the Node, sets the Node's Device Address (hexidecimal 1 to F). Each
3
Node within a network must have a unique Node Device Address.
4
3. Push button 1. Single-click to advance across all top-level DX80
menus. Single-click to move down interactive menus, once a top-level
menu is chosen.
4. Push button 2. Double-click to select a menu and to enter manual
scrolling mode. Double-click to move up one level at a time.
5
5. LED 1 and 2. Provide real-time feedback to the user regarding RF link
6
status, serial communications activity, and the error state.
7
6. LCD Display. Six-character display provides run mode user information
and shows enabled I/O point status. This display allows the user to
conduct a Site Survey (RSSI) and modify other DX80 configuration
parameters without the use of a PC or other external software interfaces.
On the Node, after 15 minutes of inactivity, the LCD goes blank. Press
any button to refresh the display.
7. 5-pin M12 Euro-style quick disconnect serial port.
1. Industrial ethernet port, female.
1
2
2. Housing. The rugged, industrial DX80 housing meets IEC IP67
standards.
3
3. Mounting hold, #10/M5 clearance. Mounting Holes accept metric
M5 or UNC/UNF #10 hardware -- DIN rail mount adapter bracket
available.
4. 5-Pin M12 Euro-style quick-disconnect serial port
4
www.bannerengineering.com - Tel: + 1 888 373 6767