Table of Contents
Advertisement
In the example shown, the input is considered on at 15 mA. To consider the input off at 13 mA, set the
hysteresis to 2 mA. The input will be considered off when the value is 2 mA less than the threshold.
Setting threshold and hysteresis points prevents inputs from oscillating between 'on' and 'off' when the
input remains close to the threshold point.
timeout interval
The Timeout Interval is the total elapsed time before the system flags an error condition. This is a
calculated value from Polling Interval (sec) × Maximum Misses.
topology
Topology is the pattern of interconnection between devices in a communication network. Some
examples include point to point, bus, ring, tree, mesh, and star configurations.
transceiver
A transceiver includes both a transmitter and receiver in one housing and shares circuitry; abbreviated
as RxTx.
wireless sensor
A wireless sensor network is a network of low-power electronic devices that combine sensing and
network (WSN)
processing ability. The devices use radio waves to communicate to a gateway device, connecting
remote areas to the central control process.
Yagi
Yagi is the name commonly given to directional antennas. The full name of the antenna is a Yagi-Uda
antenna, named for the developers Shintaro Uda and Hidetsugu Yagi, both of Tohoku Imperial
University in Sendai, Japan. Yagi antennas may also be called beam antennas or directional antennas.
6.6 Contact Us
Banner Engineering Corporate headquarters is located at:
9714 Tenth Avenue North
Minneapolis, MN 55441, USA
www.bannerengineering.com
Website:
Phone: + 1 888 373 6767
For worldwide locations and local representatives, visit
ON point
Threshold
Hysteresis
Input
OFF point
Time
www.bannerengineering.com
www.bannerengineering.com - Tel: + 1 888 373 6767
®
Sure Cross
Performance DX80 Wireless I/O Networks
.
67
Advertisement
Table of Contents
