Banner Sure Cross P2-KR Manual

Sure Cross Performance P2-KR Gateway
®
Datasheet
®
The Sure Cross wireless system is a radio frequency network with integrated I/O that operates in most environments to eliminate
the need for wiring runs.
For additional information, updated documentation, and a list of accessories, refer to Banner Engineering's website,
www.bannerengineering.com/wireless
WARNING:
• Do not use this device for personnel protection
• Using this device for personnel protection could result in serious injury or death.
• This device does not include the self-checking redundant circuitry necessary to allow its use in
personnel safety applications. A device failure or malfunction can cause either an energized (on) or de-
energized (off) output condition.
Important:
• Electrostatic discharge (ESD) sensitive device
• ESD can damage the device. Damage from inappropriate handling is not covered by warranty.
• Use proper handling procedures to prevent ESD damage. Proper handling procedures include leaving
devices in their anti-static packaging until ready for use; wearing anti-static wrist straps; and
assembling units on a grounded, static-dissipative surface.
Models
Models Frequency
DX80G2M6S-P2-KR 2.4 GHz ISM Band
Configuration Instructions
Setting Up Your Wireless Network
To set up and install your wireless network, follow these steps.
Disconnect the power from your Sure Cross devices.
1. Configure the DIP switches of all devices.
2. If your device has I/O, connect the sensors to the Sure Cross devices. If your device does not have I/O, skip this step.
3. Refer to the wiring diagrams to apply power to all devices.
• For housed models, the Gateway's LED 1 is solid green and the Node's LED 2 flashes red to indicate there is no radio
link to the Gateway.
• For board-level models, the Gateway's LED is solid green and the Node's LED flashes red to indicate there is no radio
link to the Gateway.
4. Form the wireless network by binding the Nodes to the Gateway. If the binding instructions are not included in the
datasheet, refer to the product manual for binding instructions.
Original Document
182821 Rev. B
• Wireless industrial I/O device with four selectable discrete inputs, four sourcing discrete
sourcing outputs, two universal analog inputs, and two 0 to 20 mA analog outputs
• 10 to 30 V dc power input
• DIP switches for user configuration
• Modbus serial interface
• Site Survey analyzes the network's signal strength and reliability and displays the results on
the Gateway's LCD
• Frequency Hopping Spread Spectrum (FHSS) technology ensures reliable data delivery within
the unlicensed Industrial, Scientific, and Medical (ISM) band
• Transceivers provide bidirectional communication between the Gateway and Node, including
fully acknowledged data transmission
• Lost RF links are detected and relevant outputs set to user-defined conditions
.
Environmental Rating
IP67, NEMA 6
18 January 2019
I/O
Inputs: Four selectable discrete, two 0 to 20 mA or 0 to 10 V analog
Outputs: Four sourcing discrete, two 0 to 20 mA analog
182821