Accessing The Web-Based Configuration Screens - Banner Sure Cross DX80 Series Instruction Manual

Wireless i/o networks

Table of Contents

Sure Cross

Performance DX80 Wireless I/O Networks

Example Layout #3—This example system layout may also be configured using the web pages. Instead of using a

GatewayPro to connect to the host system, a Gateway and Ethernet Bridge is used to achieve the same function. In this

configuration, the Gateway is Modbus Slave 1.

Host

Typically, the Modbus RTU connection at a GatewayPro is not used because the GatewayPro contains a master and slave

device. The Modbus RTU factory default settings for a standard Gateway are: 19200 baud; 8 data bits; No stop bits; 1 parity

bit; Modbus Slave ID 1.

5.2.1 Accessing the Web-based Configuration Screens

The configuration Web pages are served from the DX83 Ethernet Bridge or GatewayPro and are accessed using any

Internet browser.

Before accessing the Web-based configuration screens, configure the browser for a direct connection to the Internet. If you

are experiencing problems connecting, verify the browser is not set to use a proxy server. Use a crossover Ethernet cable

when connecting directly from a host computer to the DX83 Ethernet Bridge or GatewayPro; use a standard Ethernet cable

when connecting through a switch or Ethernet hub.

The factory default IP address for the DX83 Ethernet Bridge or GatewayPro is: 192.168.0.1 To change the default IP

address, set up the host PC with an IP address different from the Ethernet Bridge or GatewayPro IP addresses. (Refer to

Banner document p/n 133116 for detailed instructions on setting up the host computer's network IP address.) For example,

change the PC host IP address to: 192.168.0.2. To access the configuration screens, follow these steps.

1. Open a Web browser and log into the Ethernet Bridge or GatewayPro by typing the IP address in the browser

location window: http://192.168.0.1.

The Web home page for the Ethernet Bridge or GatewayPro displays.

2. Click on any tab at the top of page to log into the configuration software.

3. Enter system as the user name and admin as the password.

After making your changes and saving the file, close the browser to log out of the configuration system.

www.bannerengineering.com - Tel: + 1 888 373 6767

1. Ethernet crossover cable using the Modbus/TCP or

EtherNet/IP communication protocol

2. Power connection

3. DX83 Ethernet Bridge

4. Splitter cable CSRB-M1250M125.47M125.73 using

Modbus RTU

5. Gateway

Table of Contents