Dx80 Gatewaypro; Dx83 Ethernet Bridge - Banner SureCross DX80 Product Manual

SureCross DX80 and Performance DX80 Product Manual
The GatewayPro has no serviceable parts inside the housing and no wiring chamber. During setup or standard operation,
there should not be a need to open the GatewayPro.

2.3 DX80 GatewayPro

The GatewayPro has many of the same features as the Gateway and Node, including the LEDs, the buttons, LCD, and Euro-style connec-
tor.

2.4 DX83 Ethernet Bridge

The DX83 Ethernet Bridge uses the same housing and same mounting holes as the Gateway and Node.
Rev. J
1. Housing. The rugged, industrial DX80 housing meets IEC
1
IP67 standards.
2
2. Mounting hold, #10/M5 clearance. Mounting Holes accept
metric M5 or UNC/UNF #10 hardware -- DIN rail mount adapt-
er bracket available.
3. Wiring terminal strip. The 16 spring-clip type wiring termi-
3 nals accept wire sizes: AWG 12-28 or 2.5 sq mm.
4. Port, PG-7 gland or blank. The PG-7 threaded ports can ac-
4
cept provided cable glands or blanks.
5
5. Ribbon connector. Ribbon cable connects wiring base to
LCD/radio.
1. Industrial ethernet port, female.
1
2. Rotary switch 1 (left). Sets the Network ID (NID) to a hexidecimal
value from 0 to F, for a total of 16 Network IDs. A Gateway and its cor-
2
responding Nodes must be assigned the same Network ID.
3. Rotary switch 2 (right). On the Gateway, sets the Gateway's LCD
viewing device address. The Gateway is predefined as Device Address 0.
On the Node, sets the Node's Device Address (hexidecimal 1 to F). Each
3
Node within a network must have a unique Node Device Address.
4
3. Push button 1. Single-click to advance across all top-level DX80 me-
nus. Single-click to move down interactive menus, once a top-level
menu is chosen.
4. Push button 2. Double-click to select a menu and to enter manual
scrolling mode. Double-click to move up one level at a time.
5
5. LED 1 and 2. Provide real-time feedback to the user regarding RF link
6
status, serial communications activity, and the error state.
6. LCD Display. Six-character display provides run mode user informa-
7
tion and shows enabled I/O point status. This display allows the user to
conduct a Site Survey (RSSI) and modify other DX80 configuration pa-
rameters without the use of a PC or other external software interfaces.
On the Node, after 15 minutes of inactivity, the LCD goes blank. Press
any button to refresh the display.
7. 5-pin M12 Euro-style quick disconnect serial port.
www.bannerengineering.com - tel: 763-544-3164 9