Cti Calls; Beep On Auto-Answer; Beep On Auto-Reconnect - Unify OpenScape Desk Phone CP400 User Manual

Settings
$ User settings -
if nec.
$ Configuration -
$ Incoming calls -

CTI calls

-
¢
AutoAnswer
¢
AutoAnswer beep
Q
CTI calls

Beep on auto-answer

When you dial a number with a CTI application (e.g. Outlook) and auto-answer
is activated, the phone switches automatically to speakerphone mode. If auto-
answer is deactivated, the phone first rings and you have to press the loud-
speaker key or lift the handset in order to set up the call. This setting also defines
whether or not incoming calls are automatically accepted. If the function is ac-
tive, an alert beep sounds when a call is automatically accepted.
Information on the operation of the configured CTI application can be found in
the corresponding operating instructions.
z
You can also configure this setting via the web interface
ñ
The option was programmed by your administrator.
@
Press the key shown if appropriate.
_ Open using the Softkey.
Open using the Softkey.
_
j
Enter and confirm the User password.
_ Open using the Softkey.
Open using the Softkey.
_
_ Open using the Softkey.
Enable or disable using the Softkey.
_
and
€
Switch to AutoAnswer beep.
Enable or disable using the Softkey.
_
Save the setting with the Softkey.
_

Beep on auto-reconnect

You can reconnect a held call both via the CTI application and via the phone. A
beep sounds when you toggle between an active call and a held call when the
function is active.
z
You can also configure this setting via the web interface
143
page 172.

page 172.
