Pagewriters With Serial Number Prefix Prior To 3208A; Removing The Printhead Cover - HP PageWriter XL M1705B Service Manual

PageWriters with Serial Number Prefix Prior to 3208A
If the PageWriter has a serial number prefix prior to 3208A, use this
procedure to remove the printer drive assembly.
To remove the printer drive assembly:
1. Remove the keyboard and the user interface assembly as described
previously in this chapter.
2. Remove the printer door:
a. Release the latch and pull the door out to the first stop.
b. Compress and remove the plastic retainer clip at the end of the
rear aluminum rail.
c. Slide the door out of the rails and set it aside.
3. Lift off the printhead cover as shown in Figure 7-7. As you lift off
the cover, note how the tabs on the printhead cover interlock with
the other plastic parts of the top cover.
/Y
"1700-2
Figure 7-7. Removing the Printhead Cover.
4. Remove the four screws that attach the keyboard ground plane
to the upper chassis and set the keyboard ground plane aside.
Callout D in Figure 7-8 shows two of the screws.
Removal and Replacement 7-9