Receive; Autodial - HP PageWriter XL M1705B Service Manual

change, and type the new number. The new character will replace
the old one.
Or you
can use the backspace key to erase back to the
character you want to change, then retype the erased part, with any
changes you want to make.
Receive
When you select Receive,
the parameter selection display appears.
The following table lists each parameter and the settings available.
The default setting for each parameter is shown in boldface type.
Parameter
Connection?
Table 2-5. Site Receive Configuration
Setting Choices
Comments
None
Direct
Hard wire connection to receiver.
Programmable Modem
The Hayes@ M17OGA/B modem.
Hardware Modem
Not supported.
Fax/programmable modem
A.02.XX and higher software using M1756A
modem.
8
A.03.X3 and higher software using M170GB
modem.
Baud Rate? 91300
Defaults: 9600 for Direct, 2400 for
19200
Programmable Modem and Fax/programmable
300
modem, 1200 for Hardware Modem. This
1200
parameter does not, appear if you select "None"
2400
as the connect,ion type.
AutoDial
When you select AutoDial from the "Configure" menu, the
AutoDial site? prompt appears in the display. Use the Choose
softkey to select the site (1, 2, 3, 4, or None) that the cardiograph
will automatically dial when the operator issues a transmit
command.
2-30 Installation and Configuration