Connecting The Patient Module - HP PageWriter XL M1705B Service Manual

6. Press Choose until you see the choice LaserJet, then press
Enter. The baud rate display will appear.
7. Press Choose until you see the baud rate 19200, then press
Enter.
8. Select whether to print a grid.
If you have unlined paper in the printer, this selection will print
the grid with the ECG.
Your cardiograph is now set up to print to an HP LaserJet when
you select the configured site from the Transmit menu. See the
Page Writer XLi Operating Guide
for information about transmitting
ECGs.
Connecting the Patient
1. Connect the patient data cable to the ECG input jack on the back
Module
of the cardiograph.
2. Connect the other end of the patient data cable to the patient
module as shown in Figure 2-4.
3. Connect the leadwires to the patient module. Match the color
coding on the leadwires to the color coding on the patient module.
(M1702A only: Match the labels on the leadwires to the labels on
the patient module.)
4. Install shorting plugs in the patient module in those positions
without leadwires.
Figure 2-4. Connecting the Patient Module.
A. Leadwires
B. Patient Data Cable
Installation and Configuration 2-7