The Printer Drive Assembly; Removing The Printer Drive Assembly; Pagewriters With Serial Number Prefix 3208A Or Later; Removing The Printhead Cover - HP PageWriter XL M1705B Service Manual

The Printer Drive
Assembly
This section describes how to remove and replace the printer drive
assembly.
Removing the Printer
The procedure you will use depends on the serial number prefix of
Drive Assembly
the unit you are servicing. Make sure you use the correct procedure
for your particular unit.
PageWriters with Serial Number Prefix 3208A or Later
If the PageWriter has a serial number prefix of 3208A or later, use
this procedure to remove the printer drive assembly.
To remove the printer drive assembly:
1. Remove the keyboard and the user interface assembly as described
previously in this chapter.
2. Remove the printer door:
a. Release the latch and pull the door out to the first stop.
b. Compress and remove the plastic retainer clip at the end of the
rear plastic rail.
c. Slide the door out of the rails and set it aside.
3. Lift off the printhead cover as shown in Figure 7-5. As you lift off
the cover, note how the tabs on the printhead cover interlock with
the other plastic parts of the top cover.
Figure 7-5. Removing the Printhead Cover.
Removal and Replacement 7-7