Removing The Printhead Cover And Printhead - HP PageWriter XL M1705B Service Manual

c. Slide the door out of the rails and set it aside.
2. Remove the user interface assembly as described previously in
this chapter.
3. Open the top cover as described previously in this chapter.
4. Remove the right side plastic cover.
5. Disconnect the two printer cables at J2 and J5 (see Figure 7-20
for the connector locations).
6. Close the top cover but do not reinstall the screws. (You need to
open the cover again when you install the new printhead.)
7. Remove the printhead cover as shown in Figure 7-16.
Figure 7-16. Removing the Printhead Cover and Printhead.
8. Remove the screws that attach the motor ground spring and
printhead ground braids to the upper chassis.
9. Pull the leaf spring up and out of its slots in the well.
10. Remove the two screws holding the ground straps to the upper
chassis.
11. Carefully slide the printhead assembly up and out of the printer
well. Pull the two ribbon cables from the slots in the top cover.
7-22 Removal and Replacement