Suzuki Grand Vitara Service Manual page 123

DTC Confirmation Procedure
1) With ignition switch turned OFF, connect scan tool.
2) Turn ON ignition switch and clear DTC using scan tool.
3) Keep the accelerator pedal at idle position for 2 seconds.
4) Keep the accelerator pedal at fully depressed position for 2 seconds.
5) Repeat Step 3) and 4) for 3 times.
6) Check DTC.
DTC Troubleshooting
NOTE
Before this trouble shooting is performed, read the precautions for DTC troubleshooting referring to
"Precautions For DTC Troubleshooting: ".
Step
1 Was "Engine and Emission Control System Check"
performed?
2 Throttle position sensor and its circuit check
1) Connect scan tool to DLC with ignition switch turned
OFF.
2) Turn ON ignition switch, check "TP Sensor 2 Volt"
displayed on scan tool when accelerator pedal is idle
position and fully depressed.
Is displayed TP sensor value as described voltage in "Scan
Tool Data: "?
3 ECM voltage check
1) Disconnect connector from electric throttle body
assembly with ignition switch turned OFF.
2) Check for proper connection to electric throttle body
assembly at "RED", "WHT" and "GRN" wire terminals.
"BLU/YEL"
"BLU/RED"
"BLK"
3) If OK, measure voltage between "WHT" wire terminal of
electric throttle body assembly connector and engine
ground with ignition switch turned ON.
Is voltage 4 – 6 V?
www.CarGarage.ir
Action
For J20 engine
"RED"
"GRN"
"WHT"
"BLK"
For M16 engine
"GRN"
"RED"
"BLU/YEL"
"WHT"
"BLU/RED"
www.CarGarage.ir
Engine General Information and Diagnosis:
Yes
Go to Step 2.
Intermittent trouble.
Check for intermittent
referring to "Intermittent
and Poor Connection
Inspection: in Section
00".
Go to Step 5.
I5JB0A110042-01
I5JB0A110043-01
1A-116
No
Go to "Engine and
Emission Control
System Check: ".
Go to Step 3.
Go to Step 4.