Suzuki Grand Vitara Service Manual page 240

1A-233 Engine General Information and Diagnosis:
Resistance Check
1) Remove ECM from its bracket referring to "Engine Control Module (ECM) Removal and Installation: in Section
1C".
CAUTION
!
Never touch terminals of ECM itself or connect voltmeter or ohmmeter (2).
2) Connect special tool to ECM connectors securely.
NOTE
Do not connect the other connector of special tool to ECM.
3) Check resistance between each pair of terminals of disconnected connectors (1) as listed in the following table.
CAUTION
!
• Be sure to connect ohmmeter probe from wire harness side of coupler.
• Be sure to turn OFF ignition switch for this check.
• Resistance in the following table represents that measured when parts temperature is 20 °C (68 °F).
Terminals
E23-60 to E23-29 Main relay
E23-15 to E23-29 Fuel pump relay
C37-16 to E23-1/16 No.3 fuel injector
C37-17 to E23-1/16 No.4 fuel injector
C37-5 to E23-1/16 EGR valve (stepping motor No.1 coil)
C37-13 to E23-1/16 EVAP canister purge valve
C37-2 to E23-1/16 No.2 fuel injector
C37-6 to E23-1/16 EGR valve (stepping motor No.2 coil)
C37-3 to E23-1/16 EGR valve (stepping motor No.4 coil)
C37-4 to E23-1/16 EGR valve (stepping motor No.3 coil)
C37-1 to E23-1/16 No.1 fuel injector
C37-33 to E23-1/16 Intake manifold tuning vacuum solenoid valve
C37-60 to C37-59 Oil control valve (for M16 engine)
E23-50 to E23-1/16 Throttle actuator control relay
www.CarGarage.ir
1
2
Circuit
www.CarGarage.ir
I4RS0A110086-02
Standard resistance
Battery disconnected
160 – 240 Ω
and ignition switch
turned ON
160 – 240 Ω
10.8 – 18.2 Ω
20 – 31 Ω
28 – 35 Ω
10.8 – 18.2 Ω
20 – 31 Ω
10.8 – 18.2 Ω
33 – 45 Ω
6 – 15 Ω
160 – 240 Ω
Condition
—
—
—
—
—
—
—
—
—
—