Suzuki Grand Vitara Service Manual page 208

1A-201 Engine General Information and Diagnosis:
DTC Troubleshooting
NOTE
Before this trouble shooting is performed, read the precautions for DTC troubleshooting referring to
"Precautions For DTC Troubleshooting: ".
Step
1 Was "Engine and Emission Control System Check"
performed?
2 Accelerator pedal position (APP) sensor assembly
mounting check
1) Check that accelerator pedal position (APP) sensor
assembly has been mounted to vehicle body properly
(no pinched floor carpet, etc).
Is it OK?
3 Accelerator pedal position sensor (sub) and its circuit
check
1) Connect scan tool to DLC with ignition switch turned
OFF.
2) Turn ON ignition switch, check "APP Sensor 2 Volt"
displayed on scan tool.
Is displayed voltage below 0.1 V?
4 ECM voltage check
1) Disconnect connector from accelerator pedal position
(APP) sensor assembly with ignition switch turned OFF.
2) Check for proper connection to accelerator pedal
position (APP) sensor assembly at "ORN/BLU", "BLU/
GRN" and "BLU/YEL" wire terminals.
"ORN BLU"
3) If OK, measure voltage between "ORN/BLU" wire
terminal of accelerator pedal position (APP) sensor
assembly connector and vehicle body ground with
ignition switch turned ON.
Is voltage 4 – 6 V?
5 ECM voltage check
1) Turn OFF ignition switch.
2) Remove ECM from its bracket with ECM connectors
connected.
3) Check for proper connection of ECM connector at "E23-
53" terminal.
4) If OK, measure voltage between "E23-53" terminal of
ECM connector and engine ground with ignition switch
turned ON.
Is voltage 4 – 6 V?
Action
"ORN"
"WHT/BLU"
"BLU/YEL"
"WHT"
"BLU/GRN"
www.CarGarage.ir
Go to Step 2.
Go to Step 3.
Go to Step 4.
Go to Step 7.
I5JB0A110071-01
"ORN/BLU" wire is open
or high resistance
circuit.
www.CarGarage.ir
Yes
Go to "Engine and
Emission Control
System Check: ".
Reinstall accelerator
pedal position (APP)
sensor assembly
properly referring to
"Accelerator Pedal
Position (APP) Sensor
Assembly Removal and
Installation: in Section
1C".
Intermittent trouble.
Check for intermittent
referring to "Intermittent
and Poor Connection
Inspection: in Section
00".
Go to Step 5.
Go to Step 6.
No