Xerox 2510 Service Manual page 338

-
CODE
-
0
-
1
251 5
only
DESCRIPTION CODE DESCRIPTION
CODE
1
2510
only
2
251
5
only
-
3
251 5
only
-
4
251 5
only
DESCRIPTION
Fuser Temperature
Adjustment. In order t o
increase the fuser
temperature, press the COPY
CONTRAST UP button. In
order t o reduce the
temperature, press the COPY
CONTRASTDOWN button.
The value i s between
1
and
9.
5
Notes
land 2
Exposure Adjustment
The drum
is
charged and the
illumination lamp is switched
on.
See ADJ 9.2
Enables an installed foreign
xcessory. The allowable
{alues are:
The foreign accessory
feature is enabled. a 450
ms pulse
i s
provided near
the end of each
copy.
6
Notes1
and 2
High Voltage Set-up, used t o
check and adjust the corotron
voltages. Electrostatic Series
(ADJ 9.2)
The foreign accessory
feature is disabled.
Timeout t o Power Saver
(USO), (XLA 60 Hz) or Low
I'owur (IIX), (XLA 50 I-lz)
Mode. This is the amount of
time from the ready mode t o
the power saver
(USO), (XLA
60 Hz) or low power (RX),
(XLA 50 Hz) mode and
P
(USO), (XLA 60 Hz) or L (RX),
(XLA SO Hz) i s displayed. The
time is 45 seconds plus 15
multiplied by this value. In
order to increase the time,
press the COPY CONTRAST UP
button. In order to reduce
the time, press the COPY
CONTRAST DOWN button.
Each increment represents 15
seconds. The value is
between 1
and 9. The range
of values i s from 60 t o 180
seconds.
The foreign accessory
locrluro i s
enabled.
a
450
ms pulse
is
provided near
the end of each
incrementing of the copy
count meter.
Re~istrntion, iisatl to ndjirsl,
the registration. Use the
Copy Contrast Up or Copy
Contrast Down buttons t o
change the registration.
ADJ 8.1 Registration
Timeout t o Rest (sleep) Mode.
Adjusts the amount of time
that elapes from when the
copier enters the Power Saver
mode (P displayed) until the
copier enters the Rest (Sleep)
mode (rotating segment). To
increase the time, press Copy
Contrast Up. To reduce the
time, press Copy Contrast
Down.
The timeout
=
NVM x 15
minutes,
See
ADJ 3.1
Terminates imaging after 1 t o
B feet (0.3 t o
2.8
m) of media.
The value entered may be 1
through 9. A value of 9
allows an unlimited image
length.
Setpoint for the toner
concentration.
See ADJ 9.4
Country Configuration.
1 120 VAC, 60 Hz
2 220 to
230
VAC, 50 Hz
3 240 VAC, 50 Hz
4
100 VAC, 50 or 60 Hz
Mote I : During the tests under codes 5 and
6
the fuser lamp is on.
Note 2: This test will switch on the main
drive motor. In order for the main drive
motor to run, the fusermust
b e
at the
correct temperature.
Lower
Right
Segment
NVM
Reset t o Nominal
Diagnostics