Table of Contents
Advertisement
ADJ
3.3
Timeout Interval to
Power Saver Mode
(251 5)
Purpose
The purpose i s to set the amount of time
it
takes
the copier to return t o the standby mode from
the run mode.
Introduction
The timeout interval should be set to the
requirements of the customer.
The time
i s
preset by manufacturing for 1 minute. The time
interval can be set from
45
seconds to
3
minutes.
Adjust
1. Enter the diagnostic mode.
2. Select test 1. Press Start.
3.
Use the Copy Contrast LlghterlDarker
buttons t o increaseldecrease the value
displayed on the control panel.
NOTE:
Increasing the value displayed will
increase the run time interval after the
last copy was made. One number will
increase or decrease the interval by 15
seconds,
4.
Press the Start button to enter and store the
new setting.
5. Exit
the
diagnostic
mode.
AD1 3.4
Foreign Accessory
Enablement
Purpose
The purpose
is
t o select or deselect the foreign
interface feature and determine the interaction
of the foreign interface output pulse.
Adjust
1.
Enter
the
diagnostic mode.
2.
Enter code 1 (2510 WlTag 26) or enter code
2 (25 15). Press Start.
3.
Enter
the
cleisred vnlue.
1
Function
1
value
The foreign interface i s enabled and
an output pulse is generated at the
completion of each copy.
5. Exit the diagnostic mode.
The foreign interfce is not enabled.
The foreign interface is enabled and
an output pulse i s generated each
time the copy count meter registers
on
increment.
7/92
25101251 5
4-57
ADJ 3.3, ADJ
3.3,
2
3
Hide quick links:
Advertisement
Table of Contents
