Xerox 2510 Service Manual page 241

Replacement
/
REMOVE
Figure
4.
(2510 WlTag 25 and 251 5) Remove
the Cleaner Blade
NOTE: Applying a coat of zinc stearate to te
cleaning blade before installing the
cleaning blade and retainers will
lubricate them for easier installation
of the retainers.
EANER BLADE
1. Apply a light coating of zinc stearate t o
the cleaning blade.
2. (Figure 5): lnstall the cleaner blade.
NOTE: STEP 2 A: With the cleaner blade
positions as shown, install the cleaner
blade with the arrow pointed up and
the words "THIS SIDE TOWARD
PHOTORECEPTOR
"
facing towards
you. Do not touch the edge of the
cleaner blade, that comes in contact
wirh the photoreceptor drum, with
BOTTOM OF SLOT
your fingers. If the edge is touched,
clean the blade with film remover,
Figure
5.
Install the Cleaner Blade
end dust with zinc stearale.
NOTE: STEP 2 8: Ensure that the cleaner
blade assembly is on a flat surface
when installing the cleaner blade
holders, and that the colored stripe is
installed to the outside. Ensure that
the holders are completely seated
using a
7
mm nut driver to roll down
the top edge.
REP 9.4