Control Pwb; High Voltage Power Supply (Hvps) - Xerox 2510 Service Manual

REP 3.1 Control PWB REP 3.2 High Voltage Power Replacement
Supply
(HVPS)
NOTE: Step 3 E in REMOVAL: Ensure that the
I
Parts List on PL 1.2
screws are reinstalled
for a
proper I
Parts list on PL 1.2
cloct ricnl ground,
Replacement
Removal
CAUTION
After replacing the control pwb, perform the
Route
all
High Voltage wires through the
following adjustments:
1. WARNING:
Disconnect power cord. appropriate cable ties, making sure that the
HV wires are not stressed against sharp metal.
2. Remove the left side cover.
Counlry configurnlion (ADJ 3.2).
1.
Perform the electrostntic series
3. (Figure 1): Remove the high voltage
(2510 ADJ 9.2; 251 5ADJ 9,3).
Electrostatic series
(2510: ADJ 9.2) (251 5:
power supply (HVPS).
ADJ 9.3).
Registration (ADJ 8.1).
Fuser temperature (ADJ 10.1).
Timeout interval t o rest mode
(ADJ 3 , l ) .
Toner concentration
(251 5: AD1 9.4).
Timeout Interval
to
Power Saver Mode
(ADJ 3.3).
Foreign interface (ADJ 3.4).
UNPLUG J24
IU:MOVE IIVt'S
UNPLUG RED
AND BLUE
CONNECTORS
UNPLUG GREEN AND
ORANGECONNECTORS
Flgura 1. ~ o r n o v & C l l ~ ~ l4igli Vol tnga Powor
Supply (HVPS)
REP 3.1, REP
3.2