Xerox 2510 Service Manual page 10

WARNING
A warning is used to alert the
personnel to an operating or
maintenance procedure, practice,
or condition that, if not strictly
observed, could result in injury or
loss of life.
CAUTION
A caution is used to alert the
personnel to an operailng or
maintenance procedure, practice,
or condition that, i f not strictly
observed,
could result in damage
to, or destruction of, equipment.
TagIMOD Information
This symbol identlfias
tho
component or configuration of
components in a circuit diagram
that are part of a change
identified with this TagIMOD
numbor.
This symbol identifies an entire
circuit diagram that has been
changed by this Tag/ MOD
number.
TagIMOD Information
This symbol identifies the
component or configuration of
components in
a
circuit diagram
that are not part of a change
identified with this TaglMOD
number.
This symbol idonllflos
on
entire
circuit diagram that has not been
changed by this TaglMOD number.
+
The Signal Flow
This symbol
is
used on circuit
diagrams to indicate an
interrupted signal in the
horizontal direction.
This
symbol
is
used on circuit
diagrams to indicate
a
recirculating signal,
This symbol is used on circuit
diagrams to indicate a
feedback signal.
Signal Name
The signal line i s given a name that indicates
the condition of the signal when the sign
present.
Signal name
Voltage level when the
signal i s present. The
slate of
tho
signol.
Source voltage,
DC Voltage Specifications
I
Voltage
I
Specification
7/92
Introduction
x 251012515
5 VDC
10 VFWfI
15 VDC
24
VDC
4.75 TO 5.25
VDC
2,s TO 14 VDC
14.25 TO 15.75 V I X
19 TO 35 VDC