The "Stop" Key; Imbalance Detection - Hermle OLEUM Operating Manual

Oil test centrifuge

Table of Contents

Figure24

2.6.2 The "STOP" Key

With the "stop" key (10), the run time can be interrupted, at any time, (see Figure 26). After pressing

the key, the centrifuge decelerates with the respective pre-selected intensity, down to a standstill.

Figure25

In case the rotor is not equally loaded, the drive will turn off, during acceleration. The rotor decelerates

to a standstill.

When in the display "time" (A-3), the word "error" (M11) along with the number "01" appears, the

weight difference of the samples are too large. Weigh out the samples exactly!

Load the rotor as described in chapter 2.1.2.

When inside the display "time" (A-3), the word "error" along with the number "02" appear, (see

Figure26) the potential reason for the error can be: The imbalance switch is defective.

Figure26

OLEUM_V1.19_eng

OPERATION

Table of Contents