Monthly Preventive Maintenance - Kodak X-Omat 270 RA PROCESSOR Service Manual

[12] Connect the WATER RESERVOIR or YOKE to the CROSSOVERS.
[13] Check that the WATER DISCONNECT is positioned correctly.
[14] Install the following parts. Check that each assembly seats firmly.
a. EVAPORATION COVERS
b. WET SECTION COVER
[15] Energize the PROCESSOR.
[16] Process a test film and check for correct operation of the PROCESSOR.

Monthly Preventive Maintenance

Important
Completion of the monthly preventive maintenance procedures is recommended to ensure the optimum reliability of
the PROCESSOR.
[1] De-energize the PROCESSOR.
[2] Remove the following parts:
a. WET SECTION COVER
b. WATER DISCONNECT and WATER RESERVOIR or YOKE
c. EVAPORATION COVERS
d. all CROSSOVERS
e. DRYER RACK
f. WASH RACK
Caution
To prevent contamination of the developer and fixer solutions when you remove the FIXER RACK and the
DEVELOPER RACK, place the SPLASH GUARD between the DEVELOPER TANK and the FIXER TANK.
Use the DRIP TRAY whenever you remove or install the RACKS.
[3] Install the SPLASH GUARD between the DEVELOPER TANK and the FIXER TANK.
[4] Remove the following parts:
a. DEVELOPER RACK
b. FIXER RACK
c. SPLASH GUARD
[5] Rinse all the RACKS and the CROSSOVERS with warm water, 44°C (110°F) or less. Wipe the ROLLERS
and the GUIDE SHOES with a soft, synthetic sponge.
[6] Remove and clean the CROSSOVER TROUGHS. Check that the holes in the CROSSOVER TROUGHS are
free from biological growth or other obstructions.
[7] Install the CROSSOVER TROUGHS.
SM3058-3 – May 1996
Preventive Maintenance
29