De-Energizing And Energizing The Processor; Removing The Racks With Solutions In The Tanks - Kodak X-Omat 270 RA PROCESSOR Service Manual

SERVICE MANUAL

De-energizing and Energizing the PROCESSOR

CIRCUIT
BREAKER
CB2

Removing the RACKS with Solutions in the TANKS

WATER
RESERVOIR
WATER DISCONNECT
6
H104_0390ACA
H104_0390AC
2 EVAPORATION
COVERS
WASH
DRYER RACK
RACK
Warning
Dangerous Voltage. Before you replace electrical
components, move the main wall CIRCUIT
BREAKER to "OFF". Lock the wall CIRCUIT
BREAKER and attach a MAGNETIC POWER
WARNING SIGN TL-1926 to warn others not to
energize the PROCESSOR while you are performing
service.
For most of the service procedures, the PROCESSOR
must be de-energized. To de-energize the
PROCESSOR, move the CIRCUIT BREAKER CB2
on the bottom left corner on the back of the
MULTILOADER to the "O" position and the main wall
CIRCUIT BREAKER to "OFF".
To energize the PROCESSOR, move the main wall
CIRCUIT BREAKER to "ON" and the CIRCUIT
BREAKER CB2 to the "|" position.
WET SECTION
COVER
FIXER/
WASH
CROSSOVER
DETECTOR
CROSSOVER
DEVELOPER
RACK
DEVELOPER/FIXER
CROSSOVER
FIXER
RACK
H104_0586HCA
H104_0586HA
May 1996 – SM3058-3