Kodak X-Omat 270 RA PROCESSOR Service Manual page 10

SERVICE MANUAL
PUNCH
SPROCKET
PIN
DRYER
END
BEARING
MOUNT
THRUST
WASHERS
BEARING
SPROCKET
BEARING
RETAINER
THRUST
BEARING
DRYER END
10
FEED END
WORM
GEAR (7)
DRIVE
SHAFT
DRIVE
ROLL PIN SHAFT
WASHER
E-RING
SHIM
SHIELD
SCREW (4)
WASHER (4)
LOCK WASHER (4)
H104_0148CCB
H104_0148CA
WORM GEAR (7)
DRIVE SHAFT
[5] Remove from the DRYER END of the DRIVE
SHAFT the:
• SPROCKET PIN and SPROCKET
• 2 THRUST WASHERS
• THRUST BEARING
• BEARING RETAINER and BEARING
• BEARING MOUNT
• any SHIMS and SHIELD
Important
Observe the quantity of SHIMS removed. When
assembling the DRIVE SHAFT, install the same
quantity of SHIMS.
[6] Remove the DRIVE SHAFT by slowly pulling it
toward the DRYER END of the PROCESSOR.
[7] If necessary, remove any WORM GEARS that
have wear from the DRIVE SHAFT. Use a
PUNCH to remove the ROLL PIN from the
WORM GEAR.
Important
• Check the direction of the WORM GEARS. See
the figure below for correct installation on the
DRIVE SHAFT.
• When you install the DRIVE SHAFT, install a
quantity of DRIVE SHAFT WASHERS until the
DRIVE SHAFT has minimum play from side to
side.
[8] Reverse the above procedure to install a new
DRIVE SHAFT. Install the same quantity of
SHIMS that you removed in Step 5.
[9] Adjust the tension on the DRIVE CHAIN.
FEED END
H104_0458BCA
H104_0458BA
May 1996 – SM3058-3