Adjusting The Detector Switches Up And Down - Kodak X-Omat 270 RA PROCESSOR Service Manual

SERVICE MANUAL

Adjusting the DETECTOR SWITCHES Up and Down

Important
• Be sure that the DETECTOR ROLLER moves freely up and down.
• Before you can adjust the height of the drive or non-drive side DETECTOR SWITCH, both DETECTOR
SWITCHES must be moved to the highest position because the diagnostic routine sees the SWITCHES in
parallel.
FILM
DETECTOR
HOUSING
DETECTOR
SWITCH
BRACKET
[1] On the drive side of the PROCESSOR:
(a) Loosen the 2 SCREWS that hold the DETECTOR SWITCH BRACKET to the FILM DETECTOR
HOUSING.
(b) Move the DETECTOR SWITCH BRACKET to the highest position.
[2] Do Step 1 with the DETECTOR SWITCH BRACKET on the non-drive side of the PROCESSOR.
[3] Connect the PORTABLE COMPUTER to the 15-PIN DIAGNOSTIC CONNECTOR on the ELECTRICAL
BOX.
Note
See the User Instructions, Publication Part No. 699614, for the operation of the diagnostic procedures.
[4] Enter the "SPECIFIC TEST MODE" of the diagnostic program on the PORTABLE COMPUTER.
[5] Select the "PROCESSOR SENSOR TEST". The "PROCESSOR SENSOR TEST" will provide you with the
status of the 2 film DETECTOR SWITCHES.
26
SCREWS
H104_0377BCB
H104_0377BA
May 1996 – SM3058-3