Kodak X-Omat 270 RA PROCESSOR Service Manual page 32

SERVICE MANUAL
[10] Rinse the following parts with warm water, 44°C (110°F) or less. Wipe the ROLLERS and the GUIDE SHOES
with a soft, synthetic sponge.
a. CROSSOVERS
b. EVAPORATION COVERS
c. WET SECTION COVER
Note
If necessary, you may use DEVELOPER SYSTEM CLEANER AND NEUTRALIZER on the DEVELOPER/
FIXER CROSSOVER and FIXER/WASH SYSTEM CLEANER on the FIXER/WASH CROSSOVER.
[11] Remove and clean the CROSSOVER TROUGHS. Check that the holes in the CROSSOVER TROUGHS are
free from biological growth or other obstructions.
[12] Install the CROSSOVER TROUGHS.
[13] On all RACKS, check that:
(a) all ROLLERS rotate freely
(b) the ROLLERS are clean and smooth
(c) the GEARS do not have excessive wear
(d) the BEARINGS do not have excessive wear
(e) the E-RINGS and SPRINGS are not broken, missing, or corroded
(f) the CHAIN is not worn or out of adjustment
[14] If necessary, install new parts.
[15] Check the RACKS for squareness. If necessary, see the procedure on Page 8.
[16] Check that the SLOTS in the AIR TUBES are clean and in the correct positions. If necessary clean the AIR
TUBES with a bottle brush and rinse with water.
[17] Wipe any chemical deposits from the processing section of the PROCESSOR.
[18] Install a new DEVELOPER FILTER.
[19] Allow the DETECTOR CROSSOVER to air dry before you install it in the PROCESSOR.
[20] For PROCESSORS with a WATER RESERVOIR, clean the WATER RESERVOIR. Check that the holes in
the WATER RESERVOIR are free of biological growth and other obstructions.
[21] Install the following parts. Check that each part seats firmly.
a. RACKS
b. CROSSOVERS
c. WATER RESERVOIR or YOKE and WATER DISCONNECT
d. EVAPORATION COVERS
e. WET SECTION COVER
[22] Clean the REPLENISHMENT STRAINERS located between the REPLENISHMENT TANKS and the
REPLENISHMENT PUMPS.
[23] Check the water supply FILTER. If necessary, change the FILTER.
32 May 1996 – SM3058-3