Main Drive; Removing The Drive Shaft, Drive Chain, Drive Motor, Worm Gears, And Drive Shaft Bearings - Kodak X-Omat 270 RA PROCESSOR Service Manual

Section 3: MAIN DRIVE
Removing the DRIVE SHAFT, DRIVE CHAIN, DRIVE MOTOR,
WORM GEARS, and DRIVE SHAFT BEARINGS
DRIVE CHAIN
COVER
Note
It is not necessary to remove the DRIVE MOTOR to remove the DRIVE SHAFT.
[1] De-energize the PROCESSOR.
[2] Remove:
• DRIVE CHAIN COVER
• DRIVE CHAIN
• DRIVE MOTOR (if desired)
[3] Remove from the FEED END of the DRIVE SHAFT:
• E-RING
• DRIVE SHAFT WASHER (quantity may vary)
[4] For access to the SPROCKET PIN, move the DRIVE SHAFT toward the RECEIVE END of the PROCESSOR.
SM3058-3 – May 1996
DRIVE
CHAIN
LOCK
WASHER
SPROCKET
MOUNTING
NUT (4)
GEAR
BOX
WASHER
CONNECTOR
P/J 22
MOTOR
BRACKET

MAIN DRIVE

DRIVE
MOTOR
DRIVE
BOLT (4)
MOTOR
CABLE
SHIELD
CONNECTOR
H104_0412HCB
H104_0412HA
9