Removing The Level Sensor Housing And The Level Sensor Probes; Removing The Quad Power Supply A1 - Kodak X-Omat 270 RA PROCESSOR Service Manual

Removing the LEVEL SENSOR HOUSING and the
LEVEL SENSOR PROBES
SCREW
PROBE SCREW
ESD
Possible damage from electrostatic discharge.
[1] See the illustrations to remove the desired part.
[2] When you install the new part, check that the PROBE WIRE is correctly attached to the SCREW and
WASHER. Install the GASKET SIDE of the WASHER against the TANK. See the figure.

Removing the QUAD POWER SUPPLY A1

ESD
Possible damage from electrostatic discharge.
COVER
CONNECTOR (3)
[1] De-energize the PROCESSOR.
[2] See the illustration to remove the QUAD POWER SUPPLY.
SM3058-3 – May 1996
REPLENISHER
HOSE
MANDREL
ASSEMBLY
LEVEL
SENSOR
HOUSING
CLIP
LEVEL
SENSOR
PROBE
H104_0254ACA
H104_0254AA
Corrosion deposits on the LEVEL SENSOR parts
may prevent the level sense circuit from operating
correctly. Clean or replace parts as necessary.
SCREW (4)
WASHER
SCREW
Note
FAN
POWER
SUPPLY
COVER
QUAD POWER SUPPLY
Electrical
GASKET SIDE
TANK
PROBE
H127_0153ACA
WIRE
H127_0153AA
SCREW (2)
LOCK WASHER (2)
WASHER (2)
H104_0440BCA
H104_0440BA
23