Electrical; Removing The Autotransformer T1 Or Emi Line Filter - Kodak X-Omat 270 RA PROCESSOR Service Manual

SERVICE MANUAL
Section 6: Electrical

Removing the AUTOTRANSFORMER T1 or EMI LINE FILTER

AUTOTRANSFORMER
18
EMI LINE FILTER
H104_0580CCA
H104_0580CA
[1] De-energize the PROCESSOR.
[2] For easier access, remove the BACK ACCESS
PANEL and the MULTILOADER BULKHEAD
PANEL.
[3] For more play in the HOSES, place the
MULTILOADER BULKHEAD PANEL inside
the MULTILOADER.
[4] Fully extend the PROCESSOR from the
MULTILOADER.
[5] Remove the FEED END SAFETY COVER.
[6] For easier access to the AUTOTRANSFORMER
and LINE FILTER, push the PROCESSOR back
into the MULTILOADER.
[7] Working from the back of the MULTILOADER,
remove the desired part. Record the position of
the wires for the installation of the new part.
H104_0585GCA
H104_0585GC
MULTILOADER
BULKHEAD PANEL
BACK ACESS PANEL
May 1996 – SM3058-3