Kodak X-Omat 270 RA PROCESSOR Service Manual page 27

ENTRANCE
DETECTOR Drive
ROLLER Side
[6] Adjust the drive side DETECTOR SWITCH.
(a) the top ENTRANCE DETECTOR ROLLER, and insert the 2.5 cm (1 in.) FILM STRIP between the
ENTRANCE DETECTOR ROLLERS on the drive side of the PROCESSOR.
(b) Slowly, move the DETECTOR SWITCH BRACKET down until the PORTABLE COMPUTER displays
a "Film detected" message.
(c) Move the DETECTOR SWITCH BRACKET down approximately another 1 - 2 mm (approximately
⁄
1
in.).
16
Note
Be sure that the DETECTOR SWITCH BRACKET remains in the vertical position.
(d) Tighten the 2 SCREWS to hold the DETECTOR SWITCH BRACKET in position.
(e) Remove the 2.5 cm (1 in.) FILM STRIP from between the ENTRANCE DETECTOR ROLLERS.
(f) Check the the PORTABLE COMPUTER displays the message "No film Detected".
[7] Adjust the non-drive side DETECTOR SWITCH.
(a) Insert the FILM STRIP on the non-drive side of the PROCESSOR.
(b) Do Steps 6a-f for the DETECTOR SWITCH BRACKET on the non-drive side of the PROCESSOR.
SM3058-3 – May 1996
FILM STRIP
2.5 cm (1 in.)
Electrical
H104_0577BCA
H104_0577BC
27