Removing The Dryer Heater Hr3, Dryer Blower, Or; Airflow Switch - Kodak X-Omat 270 RA PROCESSOR Service Manual

Removing the DRYER HEATER HR3, DRYER BLOWER, or

AIRFLOW SWITCH

[1] De-energize the PROCESSOR.
[2] See the illustration to remove the desired component.
Note
The AIRFLOW SWITCH snaps into the SWITCH BRACKET. It is not necessary to remove the SWITCH
BRACKET.
DRYER HEATER
Caution
• When you install a new DRYER HEATER, check that all wires are in the correct openings in the PLENUM
ASSEMBLY COVER and are not pinched.
• Install the WIRE HARNESS correctly. If the WIRE HARNESS is too close to the DRYER HEATER, the
insulation on the wires may be damaged. See the "CORRECT" figure below on the right.
DRYER
HEATER
PLENUM
ASSEMBLY
COVER
INCORRECT
SM3058-3 – May 1996
SWITCH
BRACKET
AIRFLOW SWITCH S3
WIRE HARNESS
DRYER BLOWER
PLENUM
ASSEMBLY
COVER
CORRECT
DRYER ASSEMBLY
H104_0582HCA
H104_0582HA
DRYER
HEATER
WIRE HARNESS
H104_0387BCB
H104_0387BA
13